Hi,
This morning I put the car in reverse and got a display on the dash that showed the birds-eye view of the car with an exclamation point in front of it, accompanied by a short series of beeps. The car operated just fine and I was able to drive into work. This only happens in reverse.
The display was the one that shows up on the dash when your parking proximity sensors are going off - it showed the picture of the car, as done with the proximity sensors, but instead of showing a side where the sensor detected a close object as is done with the proximity sensors, it just showed the car with an exclamation point in the front of the car (should have taken a picture, will do so later if needed). This was not the TPMS warning (I've had that before, this is definitely different). Again, this only happens when I put the car in reverse. I turned the car off and started it again, and that did not clear the warning.
I'm wondering if maybe there's an issue with one of the sensors. I looked through the manual but didn't see this warning shown in the manual anywhere.
Has anyone seen this before?
This morning I put the car in reverse and got a display on the dash that showed the birds-eye view of the car with an exclamation point in front of it, accompanied by a short series of beeps. The car operated just fine and I was able to drive into work. This only happens in reverse.
The display was the one that shows up on the dash when your parking proximity sensors are going off - it showed the picture of the car, as done with the proximity sensors, but instead of showing a side where the sensor detected a close object as is done with the proximity sensors, it just showed the car with an exclamation point in the front of the car (should have taken a picture, will do so later if needed). This was not the TPMS warning (I've had that before, this is definitely different). Again, this only happens when I put the car in reverse. I turned the car off and started it again, and that did not clear the warning.
I'm wondering if maybe there's an issue with one of the sensors. I looked through the manual but didn't see this warning shown in the manual anywhere.
Has anyone seen this before?